Headlamp Levelling; Headlamp Flasher; Lamp Monitor Buzzer - Mitsubishi Electric GRANDIS OXPE10E1 Owner's Manual

l When the key has been turned to either the
"LOCK" or "ACC" position or removed
from the ignition switch with the lamp
switch in the " " position, and the lamp
switch is turned to the "OFF" position within
approximately 3 minutes, the auto-cutout
function will not be activated.
(Even if the lamp switch is again turned to
the " " position, the lamps will not go off
automatically; the lamps will remain on as
normal.)
When you want to keep the lamps on
l Turn the switch in the "OFF" position to
switch off all lamps while the key is in the
"LOCK" or "ACC" position or remove the
key from the ignition switch.
l Turn on the lamps with the switch in the
" " or " " position again, then the
lamps will remain on.
NOTE
l It is possible to disable the lamps auto-cutout
function. For further information, we recom-
mend you to consult a MITSUBISHI
MOTORS Authorized Service Point.

Lamp monitor buzzer

E00506100012
If the driver's door is opened when the key is in the
"LOCK" or "ACC" position or removed from the
ignition switch while the lamps are on, a buzzer
will sound to remind the driver to turn off the
lamps. When the lamp auto-cutout function acts,
the buzzer will stop automatically. When this func-
tion does not act, turn off the lamp switch to stop
the buzzer.
Dipper (High/Low beam change)
E00506200114
When the lamp switch is in the " " position, the
beam changes from high to low (or low to high)
each time the lever is pulled to (1). While the high-
beam is on, the high-beam indication lamp in the in-
strument cluster will also illuminate.

Headlamp flasher

E00506300333
The high-beams flash when the lever is pulled slight-
ly (2), and will go off when it is released.
When the high-beam is on, the high-beam indica-
tion lamp in the instrument cluster will illuminate.
NOTE
l The high-beams can also flash when the
lamp switch is OFF.
l
If you turn the lamps off with the headlamps
set to high-beam illumination, the headlamps
are automatically returned to their low-beam
setting when the lamp switch is next turned
to the " " position.
Instruments and controls

Headlamp levelling

E00506400767
Headlamp levelling switch*
Except for vehicles with discharge headlamps
The angle of the headlamp beam varies depending
on the load carried by the vehicle.
The headlamp levelling switch can be used to ad-
just the headlamp illumination distance (when the
lower beam is illuminated) so that the headlamps'
glare does not distract other drivers.
Set the switch (referring to the following table) to
the appropriate position according to the number of
people and the load in the vehicle.
<6-person seat>
Vehi-
cle
condi-
tion
Switch "0" "1" "2" "3"
posi-
tion
3
"4"
3-19