Mitsubishi Electric GRANDIS OXPE10E1 Owner's Manual page 195

For emergencies
CAUTION
l If you loosen the hanger mounting bolt
too much, the holder will come free and
the spare wheel will fall down. Pay close
attention to the bolt while loosening it.
3. Unlock the hanger (A) from the holder (B)
by lifting the part that is shown by the arrow
in the drawing. Lower it to remove the spare
wheel.
6
6-10
CAUTION
l
When removing the hanger from the hold-
er or hooking the hanger onto the holder,
hold the hanger securely to avoid drop-
ping it on your feet.
To install
1. Set the spare wheel onto the centre of the
hanger (A).
2. Raise the hanger and hook it onto the holder
(B).
CAUTION
l Do not hang the holder in any position oth-
er than the hanger's correct position. The
holder could scratch the vehicle body,
and the spare wheel could fall down, re-
sulting in an accident.
3. Tighten the holder mounting bolt securely
with the wheel nut wrench.
4. Fit the cover over the hanger mounting bolt.
5. After tightening the bolt, try joggling the
spare wheel to confirm that there is no play
in the hanger.