Corner Sensor System - Mitsubishi Electric GRANDIS OXPE10E1 Owner's Manual

Corner sensor system*

E00615500039
This system operates when you are backing the ve-
hicle. It uses corner and back sensors to detect an
obstacle and sounds a buzzer to inform you of the
approximate distance to the obstacle.
CAUTION
l The corner sensor system assists you in de-
termining the approximate distance be-
tween the vehicle and an obstacle located
behind the vehicle. It has limitations in
terms of detectable areas and objects,
and may not properly detect some ob-
jects. Therefore, do not place excessive
confidence in the corner sensor system,
and operate the vehicle as carefully as
you would a vehicle without this system.
l Make sure to check the surroundings
with your own eyes to ensure safety. Do
not operate the vehicle by relying on the
corner sensor system alone.
Obstacle detection areas
E00615600199
The detection areas of the corner and back sensors
are limited to those shown in the illustration. More-
over, the sensors are unable to detect low or thin ob-
jects or objects near the rear bumper. Thus, make
sure to check the surroundings as you operate the
vehicle in a safe manner.
Corner and back sensor locations
There are two corner sensors (A) at the corners of
the rear bumper, and two back sensors (B) in the
centre of the rear bumper.
Corner sensor system detection areas
Depending on whether the vehicle is equipped with
a towing bar, you can change the corner sensor sys-
tem between the standard mode and the towing bar
mode. The towing bar mode changes the system to
exclude the area in which the towing bar is moun-
ted from the detection areas.
Vehicles without a towing bar
Starting and driving
The detection areas are within approximately
50 cm (A) from the corner sensors, 100 cm (B)
from the back sensors, and 60 cm (C) or less from
the ground surface, excluding the area approximate-
ly 10 cm (D) from the ground surface.
Vehicles with a towing bar
4
4-29