Mitsubishi Electric GRANDIS OXPE10E1 Owner's Manual page 129

Starting and driving
CAUTION
l
For vehicles with M/T, if you shift to "N"
(Neutral) position in auto-speed control
mode without pressing the clutch first,
the engine will run too fast and might be
damaged.
NOTE
l Auto-speed control may not be able to keep
your speed on uphills or downhills.
l Your speed may decrease on a steep uphill.
You must use the accelerator pedal if you
want to stay at your set speed.
l Your speed may increase to more than the
set speed on a steep downhill. You must use
the brake to control your speed. If your speed
increases too much, turn off the autospeed
4
control. (Refer to "To deactivate" on page
4-28.)
4-26
CRUISE indication lamp
E00609200161
This lamp comes on when auto-speed control is ac-
tivated by operation of the auto-speed control main
switch.
To activate
E00609300595
1. Push the main switch (A) at the end of the auto-
speed control lever.
2. Pull the lever (B) down while driving at the
desired speed.
NOTE
l If the main switch is on when the ignition
switch is turned to "LOCK" or "ACC" posi-
tion, auto-speed control will be on automati-
cally the next time you start the engine. The
CRUISE indication lamp will also come on.
You will need to reset the speed however, if
you want to use auto-speed control.
l
If the battery voltage is insufficient, the mem-
ory data for the main switch will be erased.
As a result, the CRUISE indication lamp
may not come on when you restart the engine.
If this happens, push in the main switch once
again to activate the system.
l On diesel-powered vehicles, it is not possible
to set the vehicle speed while driving in 1
gear.
To increase the set speed
E00609400323
There are 2 ways to increase the set speed.
st