Mitsubishi Electric GRANDIS OXPE10E1 Owner's Manual page 24

l If you wish to add a remote control switch,
we recommend you to contact
MITSUBISHI MOTORS Authorized Service
Point.
A maximum of 4 remote control switches are
available for your vehicle.
Procedure for replacing the remote
control switch battery
E00309500086
1. Remove the screw (A) from the remote con-
trol switch.
2. With the MITSUBISHI mark facing you, in-
sert the cloth covered tip of a straight blade
(or minus) screwdriver into the notch in the
remote control switch case and use it to open
your the case.
NOTE
l Be sure to perform the procedure with the
MITSUBISHI mark facing you. If the
MITSUBISHI mark is not facing you when
you open the remote control switch case, the
switches may come out.
Locking and unlocking
3. Remove the remote control transmitter from
the remote control switch case. Then, open
the remote control transmitter using the meth-
od described in step 2.
4. Remove the old battery.
5. Install a new battery with the + side (B) down.
+ side
- side
Coin type battery
CR1616
6. Close the remote control transmitter firmly.
7. Place the remote control transmitter in the re-
mote control switch case, then securely close
the remote control switch case.
8. Attach the screw (A) removed in step 1.
1-05
1