Indication Lamps; Warning Lamps; High-Beam Indication Lamp - Mitsubishi Electric GRANDIS OXPE10E1 Owner's Manual

Table of Contents

Advertisement

Instruments and controls

Indication lamps

Turn-signal indication lamps/
Hazard warning indication
lamps
These indication lamps blink on and off
when a turn-signal lamp is operating.
NOTE
l
If the blinking is too fast, the
cause may be a blown lamp bulb
or a faulty turn-signal connection.
3
When the hazard warning lamp switch is
pressed, all turn-signal lamps will flash
on and off continuously.

High-beam indication lamp

This indication lamp illuminates when
the high-beam is used.
Front fog lamp indication lamp
This lamp illuminates while the front
fog lamps are on.
Rear fog lamp indication lamp
This lamp illuminates while the rear fog
lamp is on.
3-06
Position lamp indication lamp
E00501600012
This lamp illuminates with the lamp
switch at "
" or "
Diesel preheat indication lamp
E00501700329
(diesel-powered vehicles)
This indication lamp illuminates when
the ignition switch is placed in the "ON"
position. As the glow plug becomes hot,
the lamp goes out and the engine can be
started. If it does not go off after a few
seconds, we recommend you to have the
vehicle checked.
NOTE
l
If the engine is cold, the diesel pre-
heat indication lamp is on for a lon-
ger time.
l
When the engine has not been star-
E00501800160
ted within about 5 seconds after
the diesel preheat indication lamp
went out, return the ignition
switch to the "LOCK" position.
Then, turn the switch to the "ON"
E00501900321
position to preheat the engine
again.
l
When the engine is warm, the die-
sel preheat indication lamp does
not come on even if the ignition
E00502000101
switch is placed in the "ON" posi-
tion.

Warning lamps

E00508900102
Brake warning lamp
" position
This lamp illuminates when the ignition
switch is turned to the "ON" position,
and the lamp goes off after a few seconds.
Always make sure that the lamp goes off
E00502300061
before driving.
With the ignition switch in the "ON" po-
sition, the brake warning lamp illumi-
nates under the following conditions:
l
When the parking brake lever has
been engaged.
l
When the brake fluid level in the
reservoir falls to a low level.
l
When the brake force distribution
function is not operating correctly.
CAUTION
l
In the situations listed below,
brake performance may be com-
promised or the vehicle may be-
come unstable if brakes are ap-
plied suddenly; consequently,
avoid driving at high speeds or
applying the brakes suddenly.
Furthermore,
should be brought to a stop in a
safe location and to have it
checked.
E00502400017
E00502501930
the
vehicle

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents