Mitsubishi Electric GRANDIS OXPE10E1 Owner's Manual page 236

3. Unhook the spring (E), which secures the
bulb, and remove the bulb.
4. To install the bulb, perform the removal
steps in reverse.
CAUTION
l Handle halogen lamp bulbs with care.
The gas inside halogen lamp bulbs is high-
ly pressurized, so dropping, knocking, or
scratching a halogen lamp bulb can cause
it to shatter.
l Never hold the halogen lamp bulb with a
bare hand, dirty glove, etc.
The oil from your hand could cause the
bulb to break the next time the head-
lamps are operated.
If the glass surface is dirty, it must be
cleaned with alcohol, paint thinner, etc.,
and refit it after drying it thoroughly.
Replacement of low beam (for vehicles with dis-
charge headlamps)
Do not attempt to disassemble or repair discharged
headlamps, and do not attempt to replace their bulbs.
CAUTION
l
A high voltage is present in the power cir-
cuit and in the bulbs and bulb terminals.
To avoid the risk of an electric shock, con-
tact a MITSUBISHI MOTORS Author-
ized Service Point whenever repair or re-
placement is necessary.
Maintenance
Replacement of high-beam
1. For diesel-powered vehicles, remove the
bolts (A) to remove the power steering reser-
voir tank (B).
2. Pull out the connector (D) while pressing the
tab (C). Turn the cap (E) anticlockwise and
remove it.
8
8-27