Mitsubishi Electric GRANDIS OXPE10E1 Owner's Manual page 114

On vehicles with A/T, make sure the selector
lever is in the "P" (PARK) position.
M/T A/T
6. After turning the ignition key to the "ON" po-
sition, make certain that all warning lamps
are functioning properly before starting the
engine.
7. Turn the ignition key to the "START" posi-
tion without depressing the accelerator pedal,
and release it when the engine starts.
At extreme cold ambient temperature
If the engine won't start, depress the accelerator ped-
al about halfway while cranking the engine. Once
the engine starts, release the accelerator pedal.
CAUTION
l When starting the engine, make sure that
you press on the brake pedal. At extreme
cold ambient temperature move your foot
to the brake pedal immediately after the
engine has started.
Flooded engine
If the engine was flooded during starting, first oper-
ate the starter for 5 to 6 seconds while fully depress-
ing the accelerator pedal, then start the engine with-
out depressing the accelerator pedal.
Using the MIVEC engine
The MIVEC engine automatically switches its in-
take-valve control between a low-speed mode and
a high-speed mode in accordance with driving con-
ditions for maximum engine performance.
NOTE
l To protect the engine, the high-speed mode
may not be selected while the engine coolant
temperature is low. In such a case, the engine
revolutions do not rise to over 5,000 rpm
even if the accelerator pedal is depressed.
Starting the engine (diesel-powered ve-
hicles)
E00601701242
1. Insert the ignition key and fasten the seat belt.
2. Make sure the parking brake is applied.
3. Depress and hold the brake pedal.
4. Fully depress the clutch pedal.
Starting and driving
5. Place the gearshift lever in the "N" (Neutral)
position.
6. Turn the ignition key to the "ON" position.
The diesel preheat indication lamp will first
illuminate, and then after a short time go out,
indicating that preheating is completed.
NOTE
l If the engine is cold, the diesel preheat indi-
cation lamp is on for a longer time.
l When the engine has not been started within
about 5 seconds after the diesel preheat indi-
cation lamp went out, return the ignition key
to the "LOCK" position. Then, turn the key
to the "ON" position to preheat the engine
again.
l When the engine is warm, the diesel preheat
indication lamp does not come on even if the
ignition key is placed in the "ON" position.
Start the engine by turning the ignition key
right to the "START" position.
7. Turn the ignition key to the "START" posi-
tion without depressing the accelerator pedal,
and release it when the engine starts.
4
4-11