Mitsubishi Electric GRANDIS OXPE10E1 Owner's Manual page 101

Instruments and controls
CAUTION
l
If the washer is used in cold weather, the
washer fluid sprayed against the glass
may freeze resulting in poor visibility.
Heat the glass with the defroster or demis-
ter before using the washer.
NOTE
l It is possible to spray washer fluid without ac-
tivating the wipers. To do so, hold the lever
in the pulled position and turn the ignition
switch to the "ON" or "ACC" position.
l
It is possible to cause the wipers never to op-
3
erate when washer fluid is sprayed. For fur-
ther information, we recommend you to con-
sult a MITSUBISHI MOTORS Authorized
Service Point.
On a vehicle equipped with a Multi Display
Station (MDS), the functions can be adjusted
on the screen. Refer to the separate operation
manual for details.
Rear window wiper and washer
The rear window wiper and washer switch can be
operated with the ignition switch in the "ON" or
"ACC" position.
3-24
Turn the knob, and the rear window wiper will op-
erate.
INT- The wiper operates continuously for sev-
eral seconds then operates intermittently
at intervals of about every 8 seconds
OFF- Off
The washer fluid will be sprayed onto
the rear window when the knob is turned
-
fully in either direction.
The wipers operate automatically several
times while the washer fluid is being
E00507300460
sprayed.
NOTE
l
To ensure a clear rearward view, the wiper
performs a number of continuous operations
either when the switch is moved to the
"INT" position or when the gearshift lever
(M/T) or the selector lever (A/T) is moved to
the "R" position while the switch is in the
"INT" position.
Following this continuous operation, the wip-
er will automatically switch to intermittent op-
eration.
l It is possible to spray washer fluid without ac-
tivating the wiper. To do so, hold the knob at
the end of the lever in the " " position and
turn the ignition switch to the "ON" or
"ACC" position.
l It is possible to activate the following func-
tions. For further information, we recom-
mend you to consult a MITSUBISHI
MOTORS Authorized Service Point.
On a vehicle equipped with a Multi Display
Station (MDS), the functions can be adjusted
on the screen. Refer to the separate operation
manual for details.
• Adjustment of the interval for intermit-
tent operation
• Causing the wipers to switch to continu-
ous operation when the knob at the end
of the lever is turned to the "INT" posi-
tion twice within approximately 1 second
• Changing intermittent wiper operation to
continuous wiper operation
• Causing the wiper never to operate when
washer fluid is sprayed.