Installation Requirements; Tools And Parts; Location Requirements; Minimum Dimensions - Jenn-Air JMD2124WS Installation Instructions Manual

Tools and Parts

Tools Needed
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools
listed here.
■
Measuring tape
■ Pencil
■
No. 2 Phillips screwdriver
Parts Supplied
The microwave oven is preassembled.
■ 1" (2.5 cm) mounting screws (4)
Materials needed
■ 6" (15.2 cm) Anti-Tip block (installer to provide)
Minimum Installation Clearances
For proper installation, the following minimum clearances must exist above and below the cutout opening.
A
2" (5.1 cm)
2" (5.1 cm)
2

INSTALLATION REQUIREMENTS

■
Drill
■ 1/16" (2 mm) drill bit

Minimum Dimensions

B
19"
(48.3 cm)
A. Upper oven
B. Lower cabinet
C. Counter

Location Requirements

The microwave oven may be located in a cabinet or below the
counter, and/or below a built-in oven. Check the opening where
the microwave oven will be installed. The location must provide:
■
Wood cabinetry.
■ Cutout opening that is plumb and square. See "Minimum
Cutout Dimensions" in "Minimum Dimensions" section.
■ Cutout floor that is solid, level and flush with bottom of
cabinet cutout.
■ Support for weight of at least 100 lbs (45.4 kg), which includes
microwave oven and items placed inside.
■
Grounded electrical outlet. See "Electrical Requirements"
section.
■
Minimum installation clearances for installation location. See
"Minimum Dimensions" section.
■ Complete enclosure around the recessed portion of the
microwave oven.
C
2" (5.1 cm)
2" (5.1 cm)
B
36"
(91.4 cm)
19"
(48.3 cm)