Advertisement
17.Power disconnecting memory:
and reconnect, main unit will read back these data make the alarm to resume. When in disarm, arm or valet mode, anti car-jacking mode power
off then on again, alarm will read back original position.
18.Safety door lock/unlock:
10 seconds all doors will auto lock for protection. To turn off IGN, all doors will auto unlock for take off conveniently.
19.Window (-) Output:
press
button, system will armed and window roll-up/down approximately 30 seconds.
20.Parking lights relay built-in:
turning indicator.
21.Central door lock relays built-in:
different design of car .
22.Pager output :
23.
Anti car-jack:
ways to activate this feature. While system is trigger anti-car jack mode, Lights will flash 3 times and the LED will fast flashing to show the
system is enter anti-car jacking mode. See under 24"anti-car jack mode table".
1).REMOTE ANTI-CAR JACK :
fast flash to show the system is enter anti car-jack mode.
TO EXIT: Within 60sec. after enter this mode, simply press button once , or Acc on press valet switch once LED off to confirm exit mode.
NOTE: After 60sec., to exit this mode must use your PIN code to disarm your system, please see "How to use your PIN code".
2).ACTIVE ANTI-CAR JACK:
position. This switch is not a switch at all. It is a factory switch already in your vehicle that will function Anti car-jack mode by Push or turn ON
this switch. Any factory switch in the vehicle maybe used, as long as it switches positive voltage .Ask your customer to determine which switches
will work in the vehicle. Some possible switches are light switch, radio turn-on, or defroster switches. During this switch is turned ON, while
door's been open system will enter anti-car jack mode.
TO EXIT: Within 60sec. after enter this mode, In Acc on, Push or turn anti-car jack switch OFF or press valet switch once LED off to
confirm exit this mode.
NOTE: After 60sec., to exit this mode must use your PIN code to disarm your system, please see "How to use your PIN code".
2).PASSIVE ANTI-CAR JACK:
open one of the door in Ignition on position.
TO EXIT: Within 60sec. after enter this mode, In Acc on, press valet switch once LED off to confirm exit this mode.
NOTE: After 60sec., to exit this mode must use your PIN code to disarm your system, please see "How to use your PIN code".
24.Anti car-jack mode table:
to show the system is enter anti car-jack mode.
LED flashing fast
LED flash
3 flash
Lights flash
Siren chirp
Pager output
Engine disable
Timer
0sec.
25.How to use your PIN code:
disarm your system by enter your own PIN code .(The system's factory-set PIN code is 1 . 2 . 3 . 4 )
1) Turn Ignition "OFF then ON" LED will go OFF,
2) Press and hold valet switch, LED will start flashing, the times of LED flashing is according to the PIN codes number.
3) To set your 1st PIN code (1) , press and hold valet switch, while LED flash 1 time then release valet switch LED will OFF, means your
1st PIN code (1) been programmed.
4) To set your 2nd PIN code (2) , press and hold valet switch, while LED flash 2 times then release valet switch LED will OFF, means your
2nd PIN code (2) been programmed.
5) To set your 3rd and 4th PIN code same as above instruction.
6) After 4-digit PIN code been programmed , system will be disarmed.
26.Set your own PIN code:
want to set a password of " 9 . 1 . 3 . 1 " ,Turn Ignition ON then OFF, within 10sec., Press and hold valet switch for 5sec. Until siren give 2
chirps and Lights ON, means enter this mode, release valet switch. Upon program mode, press and hold valet switch, LED will start flashing,
the times of flashing is the number of 1st PIN code, while flash 9 times, release valet switch and your 1st code been programmed. To set 2nd PIN
code, press and hold valet switch again, while LED flash 1 time, release valet switch and your 2nd code been programmed. To set 3rd and 4th
are the same as front instructions. If 4-digit codes been programmed, siren will chirp 9 and 1 and 3 and 1 to sound your new PIN codes and into
normal status, hence your new PIN codes been programmed and Light will turn off automatically.
To use this function, set sub-function NO.5 to "ON". After closer last door, turn on IGN for
This channel is a negative (-500mA) output features. To operated this option when equipped, simply
This system is build-in with a double-side point relays for Right and Left two side
Pager (-) 500mA output can be connected to alarm pager to become two way service.
This feature will protect your vehicle in the event that there is an attempt to Hi-jack the vehicle. There are three
While Ignition ON, Press button
To install this optional anti-car jack switch contact your dealer and Set sub-function Item No.8 to "ON"
If set sub-function Item No.8 to "OFF"set, system will automatic enter anti car-jack mode, when you
If enter anti car-jack mode, Parking lights will flashing 3 times and LED will fast flashing
Siren pre-warn chirps
50sec.
If you are in Anti car jack mode after 60sec. Or system in triggering, you can manually
Choose any 1-4-digit code, but the 4digit code must not be a zero. For example : Let's say you
This system is built in memory on main unit. Generally, after alarm power is cut
This system is build-in relays for door lock/unlock and available for any
+
once . The parking lights will flash 3 times and the LED will
Lights flashing once per second
Siren blowing
Pager output
Engine disable
60sec.
89sec.
Advertisement
