Lexus CT200h Operating Manual page 59

Fully extend the shoulder belt and
3
allow it to retract to put it in lock
mode. In lock mode, the belt can-
not be extended.
While pushing the child restraint
4
system into the rear seat, allow
the shoulder belt to retract until
the child restraint system is
securely in place.
After the shoulder belt has retracted
to a point where there is no slack in
the belt, pull the belt to check that it
cannot be extended.
If the child restraint has a top tether strap, the top tether strap should be
5
latched onto the top tether strap anchor. (P. 60)
Booster seat
■
Place the child restraint system
1
on the seat facing the front of the
vehicle.
Sit the child in the child restraint
2
system. Fit the seat belt to the
child restraint system according
to the manufacturer' s instructions
and insert the plate into the
buckle. Make sure that the belt is
not twisted.
Check that the shoulder belt is cor-
rectly positioned over the child' s
shoulder and that the lap belt is as
low as possible. (P. 32)
CT200h_OM_OM76174U_(U)
1-1. For safe use
I n f o r ma t i o n P r o v i d e d b y :
59
1