Lexus CT200h Operating Manual page 443

Programming an entry gate (for U.S.A. owners)/Programming a device in

the Canadian market
With one hand, press and hold the HomeLink
2
gram. With your other hand, press and release the remote control transmit-
ter every 2 seconds and repeat this cycle until the HomeLink
light starts to flash rapidly. Then, release the buttons.
Test the HomeLink
3
and observing the indicator light:
If the indicator light is solid/continuous, programming has been com-
●
pleted and your device should activate when the HomeLink
pressed and released.
If the indicator light blinks rapidly for 2 seconds and then turns into a
●
solid/continuous light, proceed to the heading "Programming a Rolling
Code System".
Repeat the steps above to program another device for any of the remaining
4
®
HomeLink
Programming a Rolling Code System
■
Locate the "learn" or "smart" but-
1
ton on the garage door opener
motor in the garage.
This button can usually be found
where the hanging antenna wire is
attached to the unit. The name and
color of the button may vary by man-
ufacturer. Please refer to the
Owner' s manual supplied with the
garage door opener motor for
details.
Press and release the "learn" or
2
"smart" button.
Perform step
onds after performing step
CT200h_OM_OM76174U_(U)
6-4. Using the other interior features
®
operation by pressing the newly programmed button
buttons.
within 30 sec-
3
.
2
I n f o r ma t i o n P r o v i d e d b y :
443
®
button you want to pro-
®
indicator
®
button is
6