Lexus CT200h Operating Manual page 124

124
3-3. Adjusting the seats
To stop the position recall operation part-way through
■
Perform any of the following:
Press the "SET" button.
●
Press button "1", "2" or "3".
●
Operate any of the seat adjustment switches (only cancels seat position recall).
●
Seat positions that can be memorized (P. 119)
■
The adjusted positions other than the position adjusted by lumbar support switch can be
recorded.
Operating the driving position memory after turning the power switch off
■
Recorded seat positions can be activated up to 180 seconds after the driver' s door is
opened and another 60 seconds after it is closed again.
In order to correctly use the driving position memory function
■
If a seat position is already in the furthest possible position and the seat is operated in the
same direction, the recorded position may be slightly different when it is recalled.
Memory recall function
Each electronic key (including a card key) can be registered to recall your pre-
ferred driving position.
Registering procedure
■
Record your driving position to button "1", "2" or "3" before performing the
following:
Carry only the key you want to register, and then close the driver' s door.
If 2 or more keys are in the vehicle, the driving position cannot be recorded
properly.
Turn the power switch to ON mode.
1
Check that the shift position is in P.
2
Recall the driving position that you want to record.
3
While pressing the recalled but-
4
ton, press and hold the door lock
switch (either lock or unlock) until
the buzzer sounds.
If the button could not be registered,
the buzzer sounds continuously for
approximately 3 seconds.
CT200h_OM_OM76174U_(U)
I n f o r ma t i o n P r o v i d e d b y :