Installing/Removing The Stack Cable; Stack Cable; Installing The Stack Cable; Removing The Stack Cable - Huawei Quidway S5600 Series Installation Manual

Installation Manual
Quidway S5600 Series Ethernet Switches
Note:
The serial ports on PCs do not support hot swapping. Therefore, do not insert or
remove a serial interface cable from a PC that is connected to a switch with power. In
connecting a PC to the switch, first connect the DB-9 connector of the console cable to
the PC and then the RJ45 connector to the switch. In disconnecting them, remove the
RJ-45 connector prior to the DB-9 connector.

3.5 Installing/Removing the Stack Cable

3.5.1 Stack Cable

To stack S5600 series switches, you need to use stack cables to connect the Fabric
ports of switches.
Figure 3-16 Diagram for stack cable
The stack cable for the S5600 series switch can be 0.65 m (2.1 ft.), 1.2 m (3.9 ft) and 5
m (16.4 ft) long. You can choose them according to your need.

3.5.2 Installing the Stack Cable

Step 1: Before you take the cable out of the package, wear an ESD wrist strip and make
sure it is well grounded.
Step 2: Insert the cable plug into the switch Fabric port flatly.
Step 3: Use a Phillips screwdriver or power screwdriver to fasten the captive screws at
both sides.

3.5.3 Removing the Stack Cable

Step 1: Wear an ESD wrist strip and make sure it is well grounded.
Step 2: Use a flat-blade screwdriver or power screwdriver to unscrew the captive
screws at both sides.
Step 3: Unplug the cable plug from the switch Fabric port flatly.
Huawei Technologies Proprietary
3-11
Chapter 3 Installing the Switch