Installing/Removing The Optional Interface Module - Huawei Quidway S5600 Series Installation Manual

Installation Manual
Quidway S5600 Series Ethernet Switches
Caution:
The S5600 stack cable is hot swappable.
When you use the flat-blade screwdriver or power screwdriver to fasten captive
screws at both sides, make sure the captive force moment is not larger than 0.4N•m.
When you connect the stack cable, the bending radius of the cable with 0.65 m (2.1
ft.) or 1.2 m (3.9 ft) in length should be no less than eight times of the cable diameter;
the bending radius of the cable with 5 m (3.9 ft) in length should be no less than 10
times of the cable diameter.

3.6 Installing/Removing the Optional Interface Module

The optional interface modules are hot-swappable.
I. Installing
Step 1: Wear an ESD wrist strip which is well grounded and take a module out of the
package.
Step 2: Using a Phillips screwdriver to remove the blank filler panel from the slot where
you plan to install the module.
Step 3: Hold the front panel of the module with both hands, align the module with the
guides in the slot and slide it gently into the slot. Push the module until it is fully in
position.
Step 4: Fasten the captive screws to fix the module using the Phillips screwdriver.
Note:
Keep the removed blank panel for future use.
When you use the Phillips screwdriver or power screwdriver to fasten captive
screws on both sides of the modular, make sure the captive force moment is not
larger than 0.4 N•m.
II. Removing
Step 1: Wear an ESD wrist strip which is well grounded.
Step 2: Use the Phillips screwdriver to unscrew the captive screws at both sides of the
module.
Step 3: Pull the module towards you until it is completely apart from the chassis bottom.
Huawei Technologies Proprietary
3-12
Chapter 3 Installing the Switch