Huawei Quidway S5600 Series Installation Manual page 13

Installation Manual
Quidway S5600 Series Ethernet Switches
II. LEDs
The S5624P/S5624P-PWR provides one power LED, one RPS LED, one fabric LED,
one module LED, one mode LED, one 7-segment digitron display, four pairs of 1000
Mbps SFP port status LEDs, and 24 pairs of 10/100/1000Base-T port status LEDs on
its front panel.
The S5624F provides one power LED, one RPS LED, one fabric LED, one module LED,
one 7-segment digitron display, 24 pairs of 1000 Mbps SFP port status LEDs, and four
pairs of RJ-45 Combo port status LEDs on its front panel.
Table 1-2 and Table 1-3 describe respectively the LEDs on the S5624P/S5624P-PWR
and S5624F.
Table 1-2 LEDs on the S5624P/S5624P-PWR
LED
Mode LED
Power LED
DC LED
Mark Status
Speed Solid green
Mode Duplex Solid yellow
Blinking green
PoE
(at 1 Hz)
Solid green
Blinking green (at 1 Hz)
PWR
Solid red
Blinking yellow (at 1 Hz)
OFF
Solid green
RPS
Solid yellow
OFF
Huawei Technologies Proprietary
1-4
Chapter 1 Product Overview
Description
The port status LEDs
showing the speed of each port.
The port LEDs are showing the
duplex mode of each port.
The port LEDs are showing the
PoE status of each port.
The switch is started normally.
The system is running power-on
self-test (POST).
The system fails the POST, or
there is another fault.
Some ports fail the POST and
do not function.
The switch is power-off.
Both the AC power supply and
the DC input operate normally.
The AC power supply fails or the
AC input is disconnected, while
the DC input operates normally.
DC input is disconnected.
are