Page 1
BPM ARM 1900f USER GUIDE HANDLEIDING MODE D’EMPLOI BEDIENUNGSANLEITUNG ANVÄNDARHANDBOK BRUGSANVISNING ANVÄNDARHANDBOK KÄYTTÖOHJE MANUAL DE USUARIO V 2.1...
Page 2
Exclusively produced for Topcom Europe NV, Grauwmeer 17, 3001 Heverlee, Belgium by Rossmax Int’l Ltd. N° 6018 Huyi Rd., Waigang, Jiading District, Shanghai China 201806 This product is in compliance with the essential requirements and other relevant provisions of the directive 93/42/EEC.
Topcom BPM 1900f Introduction Congratulations with your purchase of the Topcom BPM 1900f. This fully automatic, wrist mounted blood pressure monitor is both easy to use and ideally suited for daily measurements. The large display includes systolic, diastolic and pulse, all clearly shown at the completion of each reading.
Topcom BPM 1900f Blood pressure What is Blood Pressure? Blood pressure is the pressure exerted on the artery tube while blood flows through the arteries. The pressure measured when the heart contracts and sends blood out of the heart is systolic (highest). The pressure measured when the heart dilates with blood flowing back into the heart is called diastolic (lowest) blood pressure.
Topcom BPM 1900f Blood Pressure Fluctuation Blood pressure fluctuates all the time! You should not be worried if you encountered two or three measurements at high levels. Blood pressure changes over the month and even throughout the day depending on circumstances (state of mind, temperature, ...) Ex.
Topcom BPM 1900f Parts & buttons description Display MEMORY button POWER button Battery compartment Arm cuff Air Tube AC adapter connector Display Systolic pressure Diastolic pressure Pulse rate Battery Low indicator. When indicated, batteries need to be replaced! Number of memory...
Topcom BPM 1900f Applying the cuff Plug in the cuff connecting tube into the unit. Unwrap the arm cuff, leaving the “Index” end of the cuff through the D-ring of the cuff. Put your left arm through the cuff loop. The "OK" range indication...
Topcom BPM 1900f 10 Measurement 10.1 Procedure Press the POWER button. All display segments will appear for approximately one second before returning to “0” The unit will automatically inflate to the appropriate inflation level based on the user's pulse oscillations. Measurement will then begin.
1A (5.5¯ /2.1¯ ) • Connect the AC adapter jack with the AC adapter connector on the back of the unit. • Plug the AC adapter into the wall socket. Only use the optional Topcom BPM Arm 1900f power adapter.
13.2 Warranty handling A faulty unit needs to be returned to a Topcom service centre including a valid purchase note. If the unit develops a fault during the warranty period, Topcom or its officially appointed service centre will repair any defects caused by material or manufacturing faults free of charge.
Need help?
Do you have a question about the BPM ARM 1900f and is the answer not in the manual?
Questions and answers