Requirements; Installation And Setup - Aastra 9143i User Manual

Welcome

Requirements

The 9143i IP Phone requires the following environment:
• SIP-based IP PBX system or network installed and running with a SIP account created for the 9143i IP phone
• Access to a Trivial File Transfer Protocol (TFTP), File Transfer Protocol (FTP), Hypertext Transfer Protocol (HTTP) server,
or HyperText Transfer Protocol over Secure Sockets Layer (SSL) (HTTPS)
• Ethernet/Fast Ethernet LAN (10/100 Mbps)
• Category 5/5e straight through cabling
• For Ethernet networks that supply in-line power to the phone (IEEE 802.3af )
– For power, use the Ethernet cable (supplied) to connect from the phone directly to the network for power. (No 48v AC power
adapter required.)
– For Ethernet networks that DO NOT supply power to the phone:
– For power, use the 48V AC Power Adapter (included) to connect from the DC power port on the phone to a power source.
or
– (optional) - For power, use a Power over Ethernet (PoE) power injector or a PoE switch. A PoE power injector is available as an
optional accessory from Aastra Telecom. Contact your Administrator for more information.

Installation and Setup

If your System Administrator has not already setup your 9143i phone, please refer to the Aastra 9143i Installation Guide
for basic installation and physical setup of the 9143i. For more advanced administration and configuration information,
System Administrators should refer to the Aastra Models 9000i and 6700i Series SIP IP Phones Administrator Guide.
2
41-001383-00 REV01 – 06.2013