Aastra 9143i User Manual page 121

• Custom - The Custom mode allows you to configure CFWD for a specific account or all accounts. You can configure a
specific mode (All, Busy, and/or No Answer) for each account independently or all accounts. On the 9143i, you can set all
accounts to ALL On or ALL Off.
Note:
If there is only one account configured on the phone, then the mode setting is ignored and the phone behaves as if the
mode was set to "Phone".
You can enable different CFWD rules/modes independently (for example, you can set different phone numbers for Busy,
All, and NoAns modes and then turn them on/off individually).
The following table describes the key and Message Waiting Indicator (MWI) LEDs when you enable CFWD on the IP Phone.
Key LED Behavior
for All Modes
CFWD key LED RED if CFWD All, CFWD
Busy, or CFWD No Answer is enabled for
the account in focus.
CFWD key LED OFF if any CFWD mode is
disabled.
Note:
If you make changes to the configuration for CFWD via the IP Phone UI, you must refresh the Aastra Web UI screen to
see the changes.
Configuring CFWD Using the Aastra Web UI
Aastra Web UI
Use the following procedure to configure CFWD using the Aastra Web UI.
1. Click on Basic Settings->Preferences->General.
41-001383-00 REV01 – 06.2013
MWI LED Behavior
for All Modes
MWI LED ON if current account in focus has
CFWD ALL enabled.
MWI LED OFF if CFWD All is disabled.
Managing Calls
115