5. Remove the fasteners securing the upper rear body
panel to the cargo box.
INSTALLING
1. Secure the upper rear body panel to the cargo box and
tighten the cap screws to 15 in.-lb.
2. Install the cargo box into position so the upper body
panel is over the top of splash guard; then tighten the
cap screws to 5 ft-lb.
34
WT234A
3. Secure the cargo box with self tapping screws and
tighten to 5 ft-lb.
4. Install the LED taillight assembly.
5. Install the rear fenders; then install the seats making
sure they lock securely in place.
REMOVING/INSTALLING
1. To remove a seat, pull the seat lock lever up. Raise the
rear of the seat and tilt it forward.
WT230A
2. To install a seat, slide the front of the seat into the seat
retainers and push down firmly on the rear of seat. The
WT231A
seat should automatically lock into position.
CHECKING/ADJUSTING
NOTE: The ROPS must be fully installed whenever
adjusting the doors in any way.
Inspect the doors for broken or bent tubes, hinges, or
latches. Make sure the latches engage and lock securely; if
not, us the following instructions.
1. Open the door to ensure it swings freely. If not, loosen
the two top fasteners and adjust door as necessary
until it swings freely. Tighten the fasteners securely.
Seats
Doors
WT229
WT003A