Table of Contents
Advertisement
5
If you are installing a Studio Spot 575 or Studio Spot 250 fixture, you must
attach a light block to each side of the fixture. The light blocks will prevent
damage to the inside of the Ecodome housing.
Caution:
Using a 3/32" allen wrench (for Studio Spot 575 fixtures) or a #2 Phillips-head
screwdriver (for Studio Spot 250 fixtures), remove the two outer screws on
the bottom of the fixture's yoke. Insert an 8-32 pan head screw in each outer
screw hole on the bottom of the fixture's yoke. Do not fully tighten the screws.
Install the light block by placing the large ends of its keyhole slots over the
two 8-32 pan head screws on the fixture's yoke. Lightly press down on the
light block until the screws are in the small end of the keyhole slots. Tighten
the screws securely.
Replace the outer screws on the bottom of the fixture's yoke
2-4
Installing the Fixture
Failure to install light blocks will result in damage to
the Ecodome Housing.
Studio Spot 575
Install the light block
Studio Spot 250
Ecodome
®
User Manual
Advertisement
Table of Contents
