Inventory - Grizzly T10875 Owner's Manual

Inventory

The following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
NOTICE
If you cannot find an item on this list, care-
fully check around/inside the machine and
packaging materials. Often, these items get
lost in packaging materials while unpack-
ing or they are pre-installed at the factory.
Box 1 (Figures 3–5)
A. Grinder ....................................................... 1
B. Rotating Shaft ............................................. 1
A
Figure 3. Model T10875 grinder.
-12-
C. Spark Deflector ........................................... 1
D. Tool Rest (Left) ........................................... 1
E. Tool Rest (Right) ......................................... 1
F.
G. Collet Wrench ............................................. 1
Qty
H. Open-End Wrench 10mm x 7mm ............... 1
I.
J.
K. Flat Washers 4mm ..................................... 3
L. Phillips Head Screw M4-.7 x 40 ................. 1
M. Flange Nut M4-.7 ........................................ 1
N. Wing Bolts M4-.7 x 10 ................................ 2
B
Safety Shield .............................................. 1
C
F
Figure 4. Tool rest and safety shield parts.
Pin Wrench ................................................. 1
Phillips Head Screws M4-.7 x 8 .................. 2
H
G
L
N
M
Figure 5. Tool and fastener inventory.
Model T10875 (Mfd. Since 01/15)
D
E
I
K
J