Table of Contents
Advertisement
Inventory
The following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
Inventory (Figure 3):
A. Spark Arrestors .......................................... 2
B. Phillips Head Screws M5-.8 X 8 (Arrestor) . 2
C. Lock Washers 5mm (Arrestor) ................... 2
D. Flat Washers 5mm (Arrestor) ..................... 2
E. Chip Shields ............................................... 2
F.
Phillips Head Screws M5-.8 X 45 (Chip
Shield) ........................................................ 2
G. Flat Washers 5mm (Chip Shield) ............... 4
H. Lock Washers 5mm (Chip Shield) .............. 2
I.
Hex Nuts M5-.8 X 45 (Chip Shield) ............ 2
J.
Work Rests (Left and Right) ................1 Ea.
K. Hex Bolts M8-1.25 x 9.5 (Work Rests) ....... 4
L. Lock Washers 8mm (Work Rests) .............. 4
M. Flat Washers 8mm (Work Rests) ............... 4
N. Grinding Wheel 36-Grit (Pre-installed) ....... 1
O. Grinding Wheel 60-Grit (Pre-installed) ....... 1
NOTICE
If you cannot find an item on this list, care-
fully check around/inside the machine and
packaging materials. Often, these items get
lost in packaging materials while unpack-
ing or they are pre-installed at the factory.
-12-
Qty
F
K
A
B
C
D
E
G
H
J
L
Figure 3. Inventory.
Model G9717 (Mfd. Since 3/00)
I
M
Advertisement
Table of Contents
