Installing Bits - Grizzly T10875 Owner's Manual

Installing Bits

The Model T10875 uses bits and cutters with a
diameter shaft. See the Grizzly catalog or website
for a complete listing of available bits and acces-
sories.
To install a bit:
1. DISCONNECT MACHINE FROM POWER!
2. Rotate collet nut until locking holes in rotating
shaft grip align (see Figure 19), then insert
pin wrench.
Locking
Hole
Figure 19. Location of locking holes in rotating
shaft grip.
3.
Loosen collet nut by turning counterclock-
wise.
Note: DO NOT completely remove collet nut
from shaft.
4. Insert bit shank into collet.
Note: At least ⁄
1
2
mounted into end of collet.
-24-
Rotating Shaft
Grip
Collet
Nut
" of bit shank should be
5. Hand-tighten collet nut while pin wrench is
inserted into locking hole.
"
⁄
1
8
6. Tighten
1
Figure 20). DO NOT over tighten.
Figure 20. Tightening rotating shaft collet.
Using Rotating Shaft
1. Install collet and bit.
2. Grasp tool firmly.
3. Turn tool ON.
4. Ease tool against workpiece using light pres-
sure.
Note: Always test bit on a scrap piece of
material similar to workpiece.
Failure to wear safety glasses while operat-
ing grinder could cause serious personal
eye injury.
⁄ of a turn with collet wrench (see
3
Tool Bit
Shaft
Pin
Wrench
Model T10875 (Mfd. Since 01/15)