Section 3: Setup; Needed For Setup; Unpacking; Inventory - Grizzly T32002 Owner's Manual

This
serious
to untrained users. Read
through this entire manu-
al to become familiar with
the controls and opera-
tions before starting the
machine!
Wear safety glasses during
the entire setup process!

Needed for Setup

The following items are needed, but not included,
for the setup/assembly of this machine.
Description
• Safety Glasses ........................................... 1
• Phillips Head Screwdriver #2 ..................... 1

Unpacking

This machine was carefully packaged for safe
transport. When unpacking, separate all enclosed
items from packaging materials and inspect them
for shipping damage. If items are damaged,
please call us immediately at (570) 546-9663.
IMPORTANT: Save all packaging materials until
you are completely satisfied with the machine and
have resolved any issues between Grizzly or the
shipping agent. You MUST have the original pack-
aging to file a freight claim. It is also extremely
helpful if you need to return your machine later.
-16-

SECTION 3: SETUP

machine presents
injury hazards
Qty

Inventory

The following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
NOTICE
If you cannot find an item on this list, care-
fully check around/inside the machine and
packaging materials. Often, these items get
lost in packaging materials while unpack-
ing or they are pre-installed at the factory.
Box 1 (Figure 5)
A. Buffing Wheel 3"......................................... 1
B. Machine ...................................................... 1
C. Grinding Wheel 3" ...................................... 1
D. Open-End Pin Wrench 9mm ...................... 1
E. Grinding Bit
⁄ " ........................................... 1
1
8
F.
Knob M6-1 x 13 .......................................... 1
G. Tool Rest .................................................... 1
H. Safety Shield .............................................. 1
I.
Phillips Head Screws M4-.7 x 5 .................. 2
J.
Rotary Shaft ............................................... 1
B
A
E
H
G
F
I
Figure 5. Inventory.
Model T32002 (Mfd. Since 02/20)
Qty
C
D
J