DFI CT132-BR User Manual page 13

wake-on-lan
It is supported via the onboard LAN port or via a PCI LAN card
that uses the PCI PME (Power Management Event) signal. However,
if your system is in the Suspend mode, you can power-on the system
only through an IRQ or DMA interrupt.
Important:
The 5V_standby power source of your power supply must sup-
port ≥ 720mA.
wake-on-PS/2
tem.
Important:
The 5V_standby power source of your power supply must sup-
port ≥ 720mA.
wake-on-USB
from the S3 (STR - Suspend To RAM) state.
Important:
If you are using the Wake-On-USB Keyboard/Mouse function for
2 USB ports, the 5V_standby power source of your power sup-
ply must support ≥ 1.5A. For 3 or more USB ports, the
5V_standby power source of your power supply must support
≥ 2A.
This feature allows the network to remotely
wake up a Soft Power Down (Soft-Off) PC.
This function allows you to use the PS/2 key-
board or PS/2 mouse to power-on the sys-
This function allows you to use a USB key-
board or USB mouse to wake up a system
Introduction
1
13