Table of Contents
Advertisement
Settings
To enable the RAID function, the following settings are required.
1. Connect Serial ATA drives.
2. Configure Serial ATA in the Award BIOS.
3. Configure Serial ATA in the Intel RAID BIOS.
4. Install the RAID driver.
Step 1: Connect Serial ATA Drives
Connect one end of the Serial ATA cable to a SATA connector and
the other end to your Serial ATA device.
Mouse
Important:
1. Make sure you have installed the Serial ATA drives and con-
nected the data cables otherwise you won't be able to en-
ter the RAID BIOS utility.
2. Treat the cables with extreme caution especially while cre-
ating RAID. A damaged cable will ruin the entire installation
process and operating system. The system will not boot and
you will lost all data in the hard drives. Please give special
attention to this warning because there is no way of recov-
ering back the data.
KB
5
RAID
SATA
connectors
111
Advertisement
Table of Contents
