Table of Contents
Advertisement
2-channel
Light Blue
Lime
Pink
Front Audio
The front audio connector (J19) allows you to connect to the line-
out and mic-in jacks that are at the front panel of your system.
Using the line-out and mic-in jacks will disable the rear audio's line-
out and mic-in functions.
Remove the jumper caps from pins 5-6 and pins 9-10 of J19 prior
to connecting the front audio cable connector. Make sure pin 1 of
the cable connector is aligned with pin 1 of J19. If you are not using
this connector, make sure to replace the jumper caps back to their
original pin locations.
Pins 5-6 and 9-10 short
(default)
Pins 5-6 and 9-10 open
BIOS Setting
Configure the onboard audio in the Integrated Peripherals submenu
("Onboard Device" section) of the BIOS. Refer to chapter 3 for
more information.
Driver Installation
Install the audio driver. Refer to chapter 4 for more information.
4-channel
Line-in
Rear R/L
Line-out
Front R/L
Mic-in
Mic-in
The front audio is disabled.
The rear audio is enabled.
The front audio is enabled.
The rear audio is disabled.
Hardware Installation
6-channel
Rear R/L
Front R/L
Center/Subwoofer
2
37
Advertisement
Table of Contents
