Table of Contents
Advertisement
5
RAID
Step 2: Configure Serial ATA in the Award BIOS
1. Power-on the system then press <Del> to enter the main menu
of the Award BIOS.
2. Select the Integrated Peripherals submenu - > OnChip IDE
Device section of the BIOS.
3. Configure Serial ATA in the "On-Chip Serial ATA Setting" section.
x SATA Mode
x PATA IDE Mode
↑↓→←
4. Press <Esc> to return to the main menu of the BIOS setup
utility. Select "Save & Exit Setup" and press <Enter>.
5. Type <Y> and press <Enter>.
6. Reboot the system.
112
Phoenix - AwardBIOS CMOS Setup Utility
IDE HDD Block Mode
IDE DMA Transfer Access
On-Chip Primary PCI IDE
IDE Primary Master UDMA
IDE Primary Slave UDMA
On-Chip Secondary PCI IDE
IDE Secondary Master UDMA
IDE Secondary Slave UDMA
On-Chip Serial ATA Setting
***
On-Chip Serial ATA
SATA Port
: Move
Enter: Select
F5: Previous Values
Enabled
Enabled
Enabled
Auto
Auto
Enabled
Auto
Auto
***
IDE
Auto
Primary
P1, P3 is Secondary
+/-/PU/PD: Value
F10: Save
F6: Fail-Safe Defaults
Item Help
Menu Level
If your IDE hard drive
supports block mode
Select Enabled for
automatic detection of
the optimal number of
block read/writes per
sector the drive can
support
ESC: Exit
F1: General Help
F7: Optimized Defaults
Advertisement
Table of Contents
