Configure Lldp-Med Interface - NETGEAR M7100 Series User Manual

In the Fast Start Repeat Count field, enter the number of LLDP PDUs that are transmitted
8.
when the protocol is enabled.
The range is from (1 to 10). Default value of fast repeat count is 3.
The Device Class field specifies local device's MED Classification. There are four
different kinds of devices, three of them represent the actual end points (classified as
Class I Generic [IP Communication Controller and so on], Class II Media [Conference
Bridge and so on], Class III Communication [IP Telephone and so on]). The fourth device
is Network Connectivity Device, which is typically a LAN Switch/Router, IEEE 802.1
Bridge, IEEE 802.11 Wireless Access Point and so on

Configure LLDP-MED Interface


To configure LLDP-MED Interface
Prepare your computer with a static IP address in the 169.254.100.0 subnet, for
1.
example, 169.254.100.201.
Connect an Ethernet cable from an Ethernet port on your computer to an Ethernet port on
2.
the switch.
Launch a web browser.
3.
Enter the IP address of the switch in the web browser address field.
4.
The default IP address of the switch is 169.254.100.100.
The Login screen displays.
Enter the user name and password.
5.
The default admin user name is admin and the default admin password is blank, that is,
do not enter a password.
Click the Login button.
6.
The web management interface menu displays.
Select System > LLDP > LLDP-MED > Interface Configuration.
7.
The Link Status field displays the link status of the port (up or down).
The Operational Status field displays whether the LLDP-MED TLVs are transferred on
this interface.
M6100, M5300, and M7100 Series Managed Switches
Configure System Information
137