View Power Redundancy - NETGEAR M7100 Series User Manual

The following table describes the Blade Power Consumption data that is displayed.
Table 63. Chassis Power Modules
Field
Unit ID
Blade Type
Blade Model
Current Power Consumption
Blade Power Required
Blade Status

View Power Redundancy


To view power redundancy:
Prepare your computer with a static IP address in the 169.254.100.0 subnet, for
1.
example, 169.254.100.201.
Connect an Ethernet cable from an Ethernet port on your computer to an Ethernet port on
2.
the switch.
Launch a web browser.
3.
Enter the IP address of the switch in the web browser address field.
4.
The default IP address of the switch is 169.254.100.100.
The Login screen displays.
Enter the user name and password.
5.
The default admin user name is admin and the default admin password is blank, that is,
do not enter a password.
Click the Login button.
6.
The web management interface menu displays.
Select System > Chassis > Advanced > Chassis Power Configuration.
7.
M6100, M5300, and M7100 Series Managed Switches
Description
The unit ID that identifies the blade slot.
Displays blade type number.
Displays blade model.
Displays amount of power required by blade (excluding PoE
power) in watts.
Displays amount of power required by blade (excluding PoE
power) in watts.
Displays blade status. The possible values are as follows:
• OK
• Booting up
• Bootup Failed
• Thermal Shutdown
• SW Power Down
• Not Enough Power
• Unknown Blade
• Absent
Chassis and Stacking
168