NETGEAR M7100 Series User Manual page 213

M6100, M5300, and M7100 Series Managed Switches
Select the Admin Mode Disable or Enable radio button.
8.
This specifies the administrative mode for voice VLAN for the switch. The default is
Disable.
Use Interface to select the physical interface.
9.
Use Interface Mode to select the voice VLAN mode for selected interface:
10.
Disable. This is the default value.
•
None. Allow the IP phone to use its own configuration to send untagged voice traffic.
•
VLAN ID. Configure the phone to send tagged voice traffic.
•
dot1pConfigure voice VLAN 802.1p priority tagging for voice traffic. When this is
•
selected, enter the dot1p value in the Value field.
Untagged. Configure the phone to send untagged voice traffic.
•
Use Value to enter the VLAN ID or dot1p value.
11.
This is enabled only when VLAN ID or dot1p is selected as the interface mode.
In the CoS Override Mode field, select Disable or Enable.
12.
The default is Disable.
In the Authentication Mode field, select Enable or Disable.
13.
The default is Enable. When the authentication mode is enabled, voice traffic is allowed
on an unauthorized voice VLAN port. When the authentication mode is disabled, devices
are authorized through dot1x.
Authentication through dot1x is possible only if dot1x is enabled.
Note:
In the DSCP Value field, configure the Voice VLAN DSCP value for the port.
14.
The valid range is 0 to 64. The default value is 0.
The Operational State field displays the operational status of the voice VLAN on the given
interface.
Configure Switching Information
213