Table of Contents
Advertisement
Before Installing Your 600i2 Interactive Whiteboard System
In This Chapter
For instructions on installing your product, consult the SMART Board 600i2 interactive whiteboard system
installation documents that came with your product, the mounting template and the ECP mounting template.
Use these materials, found in the Unifi 45 boxes, to install your system and do not refer to the instructions
included in the SMART Board interactive whiteboard product box.
This chapter includes additional information, optional installation procedures and tips to consider before you
install a SMART Board 600i2 interactive whiteboard system.
•
Environmental Requirements
•
Before Installing Your 600i2 Interactive Whiteboard System
•
After Installing Your 600i2 Interactive Whiteboard System
Environmental Requirements
Before installing your SMART Board 600i2 interactive whiteboard system, review the following environmental
requirements.
SMART Board 600i2 interactive whiteboard systems can operate in a temperature range of 41°F to 95°F (5°C to
35°C) from sea level to an altitude up to 6000' (0 m to 1829 m) and 41°F to 86°F (5°C to 30°C) from 6000' to
9800' (1829 m to 2987 m). The product can withstand storage temperatures from minus 40°F to 122°F (minus
40°C to 50°C).
CAUTION
• Never operate this unit immediately after moving it from a cold location to a warm location.
• In a high altitude location where air is thin, cooling efficiency is reduced so use the projector
• Do not place in hot locations, such as near heating equipment. Doing so could cause a
Humidity
SMART Board 600i2 interactive whiteboard systems can operate between 30%–70% humidity, non-condensing.
Humidity above 80% might cause slight wrinkling in the sheet of the SMART Board 600 series interactive
whiteboard. The wrinkles disappear once the humidity lowers.
Water and Fluid Resistance
SMART Board 600i2 interactive whiteboard systems are for indoor use only and do not meet any
salt-spray or water ingress requirements. Do not pour or spray any liquids directly onto the interactive
whiteboard, the Unifi projector or any of its sub-components. These liquids might get into areas where they could
damage sensitive electronic components. Refer to the Maintenance section of this guide (page 25) for detailed
instructions on cleaning your system's components.
99-00850-21 A0
When the unit is exposed to such a change in temperature, moisture may condense on the
lens and crucial internal parts. Do not use the unit for at least two hours when there is an
extreme or sudden change in temperature to prevent the unit from possible damage.
with fan mode set to High.
malfunction and shorten the life of the projector.
Before Installing Your 600i2 Interactive Whiteboard System
7
Advertisement
Table of Contents
