Removing The Drain And Recirculation Pumps - Maytag MTW6300TQ Bravos Service Manual

REMOVING THE DRAIN AND RECIRCULATION PUMPS

WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Unplug washer or disconnect power.
2. Turn off the water supply to the washer.
3. Disconnect the hot and cold water hoses
from the rear of the washer, and remove
the end of the drain hose from the stand-
pipe or laundry tub.
4. Tape the washer lid closed.
5. Carefully lay the washer on its front pan-
el. Place padding on the floor to protect
the surfaces.
Drain Pump Recirculation Pump
6. To remove the drain pump:
a) Loosen the clamps and pull the inlet
and outlet drain hoses off the pump.
Note that there is a tab on the outlet
connector that fits into a slot in the
hose.
b) Remove the three 5/16˝ hex-head
screws from the drain pump and re-
move the pump from the tub.
Slide Pump Hose
Onto Connector With
Tab Into Hose Slot
Outlet Hose
c) Open the wire cover on the pump and
disconnect the 2-wire connector from
the terminals.
Continued on the next page.
4-13
Inlet Hose
Drain Pump Screws
Wire Connector
Cover