Lid Lock - Maytag MTW6300TQ Bravos Service Manual

Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.

LID LOCK

Refer to page 4-6 for the procedure for ac-
cessing the lid lock.
1. Perform the Manual: Door Lid Switch and
Manual: Door Lid Lock tests on page 6-7.
2. Remove the console to access the ma-
chine/motor control assembly (see "Ac-
cessing & Removing the Electronic As-
semblies" on page 6-15).
Visually check that the P12 connector is
3.
inserted all the way into the machine/mo-
tor control.
• If visual check passes, go to step 4.
• If visual check fails, reconnect P4 and
repeat step 1.
4. Unplug washer or disconnect power.
WARNING
Electrical Shock Hazard
5. Check the lid lock motor winding and
switches by removing P12 from the ma-
chine/motor control, and checking the
resistance values shown in the following
Lid Lock Resistance table.
Component
Motor Winding
Lock Switch -
Home
Lock Switch -
Lock
Lock Switch -
Lid
• If resistance values are good, go to
step 6.
• If switch measurements do not match
the values shown in the table for un-
locked (or locked) conditions, a prob-
lem exists in the door lid lock. Replace
the door lid lock.
6. If the Manual: Door Lid Switch or Manual:
Door Lid Lock tests in step 1 failed, then
the machine/motor control has failed:
• Replace machine/motor control as-
sembly.
• Perform the Manual: Door Lid Switch
and Manual: Door Lid Lock tests in
step 1 to verify repair.
5-3
LID LOCK RESISTANCE
Resistance Resistance
Contacts Measured
Unlocked Locked
35 ±5 Ω 35 ±5 Ω P12-2
0 Ω Open Circuit
Open Circuit 0 Ω
P12-1
Lid Closed = 0 Ω
Lid Open = Open Circuit
P12-3
P12-4
P12-7
P12-5