Administrator Settings-Multipoint Mode - Cisco TelePresence MX200 G2 User Manual

69 Settings
Administrator Settings—Multipoint Mode
To exit
Administrator
Settings, tap
Back.
To exit Settings
as such, tap
Exit.
Note that there
is no Cancel
function letting
you exit the
menu undoing
any changes you
have made.
Take care!
About Multipoint
There are basically two modes of
video conferencing; viz. MultiWay
and MultiSite.
•
To enable MultiWay, a MultiWay
address must have been entered.
•
If a MultiWay address has been
specified and MultiWay is selected,
MultiWay will always be used for
video conferencing.
•
If a MultiWay address has been
specified, but MultiSite is selected,
MultiSite will be used.
•
If set to Auto, MultiWay will be
used if a MultiWay address
has been specified, otherwise
MultiSite will be used.
•
If set to Off, no video conferencing
will be possible.
•
Any use of the MultiSite feature
requires the presence of the
MultiSite option.
Caution! There is no Cancel
function letting you exit the menu
undoing any changes you have
made. Take care!
D1507606 User Guide
Cisco TelePresence SX10, SX20, MX200 G2,
MX300 G2, MX700, MX800, SX80
Produced: December 2014 for TC 7..3
All contents © 2010–2014
Cisco Systems, Inc. All rights reserved.