Presentation Outside Calls - Cisco TelePresence MX200 G2 User Manual

33 Share content

Presentation Outside Calls

Connect your source(s) and
make sure it is switched on
and tap Share.
Tap again to stop displaying the corresponding source, as
shown.
Tap the source avatar to display this source on you video
system's display. For a dual screen system tap the other
source avatar to dsiplay that one as well. On a single
screen system there will be one source avatar shown only.
About Local Sharing
You may show content on the
system's screen(s), even if the
system is not in a call.
What you then do is to utilize the
Preview function (see also "Start and
Stop Presentation in a Call" on page
31).
On video systems with dual screens
you may share contents from two
independent sources simultaneously.
This can be done outside calls only.
The option is not available in a call.
At left we use the dual display as
example, but the principle applies to
single screen systems as well.
D1507606 User Guide
Cisco TelePresence SX10, SX20, MX200 G2,
MX300 G2, MX700, MX800, SX80
Produced: December 2014 for TC 7..3
All contents © 2010–2014
Cisco Systems, Inc. All rights reserved.