Administrator Settings-Tracking - Cisco TelePresence MX200 G2 User Manual

65 Settings
Administrator Settings—Tracking
Tap as shown to invoke the Snap
to Whiteboard setup wizard.
About Tracking
For systems with two cameras set up
for speaker tracking, this window lets
you specify the tracking mode. Select
between Normal and Fast.
In addition, this window lets you con-
figure the Snap to Whiteboard feature.
Just follow the wizard to set up this
feature.
Note! Speaker tracking microphones
are height-above-floor sensitive. This
is used to make the system respond
to a speaking person standing by the
whiteboard only. A person sitting in
front of the whiteboard will then avoid
invoking the snap feature.
To make this work the system will look
and listen for a face located in the
upper half of the defined whiteboard
area.
The whiteboard must be located on
the wall opposing the camera system.
The feature has not been designed for
any other angle of incidence.
For a more detailed discussion on the
Snap to Whiteboard feature, see the
Administrator Guide for your video
system.
D1507606 User Guide
Cisco TelePresence SX10, SX20, MX200 G2,
MX300 G2, MX700, MX800, SX80
Produced: December 2014 for TC 7..3
All contents © 2010–2014
Cisco Systems, Inc. All rights reserved.