Table of Contents
Advertisement
S
S
UPER
ERVER 5016I-MT/5016I-MTF User's Manual
Overheat (OH)/Fan Fail/Front UID
LED
Connect an LED cable to the Front
UID and OH/Fan Fail connections on
pins 7 and 8 of JF1 to display UID
(Unit ID) signals or to provide ad-
vanced warnings for chassis overheat/
fan failure. Refer to the table on the
right for pin defi nitions.
NIC1/NIC2 (LAN1/LAN2)
The NIC (Network Interface Control-
ler) LED connection for LAN port 1 is
located on pins 11 and 12 of JF1, and
the LED connection for LAN Port 2 is
on pins 9 and 10. NIC1 LED and NIC2
LED are 2-pin NIC LED headers. At-
tach NIC LED cables to NIC1 LED and
NIC2 LED to display network activities
for LAN 1 and LAN2. Refer to the table
on the right for pin defi nitions.
HDD LED
The HDD LED connection is located
on pins 13 and 14 of JF1. This LED is
used to display HDD activity. See the
table on the right for pin defi nitions.
Power On LED
The Power On LED connector is lo-
cated on pins 15 and 16 of JF1 This
connection is used to provide LED
indication of power being supplied to
the system. See the table on the right
for pin defi nitions.
OH/Fan Fail Indicator
Status
State
Defi nition
Off
Normal
On
Overheat
Flash-
Fan Fail
ing
LAN1/LAN2 LED
Pin Defi nitions (JF1)
Pin#
Defi nition
9/11
Vcc
10/12
Ground
HDD LED
Pin Defi nitions (JF1)
Pin#
Defi nition
13
+5V
14
HD Active
Power LED
Pin Defi nitions (JF1)
Pin#
Defi nition
15
+5V
16
Control
5-16
Advertisement
Table of Contents
