Maintenance Cleaning; Light Bulb Replacement - Perlick 15" Signature series Installation & Operation Manual

MAINTENANCE
CLEANING
to clean stainless steel exterior or interior surfaces,
use a soft, non-abrasive stainless steel cleaner to
wipe down the these surfaces. If you have difficulty
finding a good cleaner, try signature polish from sig-
nature limited laboratory, p.O. Box 13436, Dayton,
Ohio 45413-0436; or call toll free at 877/376-5474.
glass door panels can be cleaned using any standard
glass cleaner available on the market today.
to clean interior and exterior non-metallic surfaces
and removable parts, wash with a mild solution of
soap and lukewarm water with a little baking soda.
Rinse and dry thoroughly. avoid getting water on
lights, controllers, fan motors, and unfinished wood
wine rack faces.
CAUTION
Do not use abrasive cleaners or cloths on any of
the interior or exterior surfaces or removable
parts.
24 © 2011 15" Cabinet Installation / Operation Manual
CONDENSER CLEANING
WARNINg
For cleaning the condenser and other routine
maintenance, shut off electricity to the unit.
In all instances, you should clean the condenser area
every three months. the condenser is located be-
hind the louvered toe plate. to clean the condenser
remove the toe plate and use a soft bristle brush and
vacuum to remove dust and lint. avoid damaging or
crushing the condenser fins or tubing. upon comple-
tion, re-install the louvered toe plate.
CAUTION
Failure to clean the condenser could result in
temperature loss or mechanical failure or dam-
ages. Clean this area every three months.

LIgHT BULB REPLACEMENT

to replace a defective or burnt out light bulb, un-
screw the bulb counterclockwise and replace with
an identical 15-Watt bulb or smaller. perlick Replace-
ment Bulb Number 67026.
Document No. Z2305