Table of Contents
Advertisement
48" TWO DOOR AND DUAL-ZONE REFRIGERATOR/WINE RESERVE
Operation/Installation Manual
USE & OPERATION
Do not use or store flammable
DANGER
liquids (ie; gasoline) or vapors
near the appliance to avoid fire.
To avoid contamination, use
WARNING
food safe containers (not
included) for the storage of craft ice in the
cabinet's freezer compartment. This equipment
does not include a drain and is intended for use
with craft ice and other non-hazardous food
stored in food safe containers. Perlick
recommends the use of NSF food certified
containers.
If service is necessary, repair work
CAUTION
should be performed by a Perlick-
authorized service personnel. Work done by
unqualified individuals could create dangerous
conditions in unit that may result in serious injury or
death.
The unit must NOT be totally
NOTICE
enclosed or damage may occur.
REPAIR & MAINTENANCE
All service work shall be
WARNING
performed by Perlick-authorized
service personnel. All component parts shall be
replaced with like components. Incorrect parts or
improper service may result in fire.
INSTALLING CASTERS OR LEGS (OPTIONAL)
Attach bracket assembly to the bottom of the cabinet
base using the ¼"-20 Philips head machine screws
provided. Attach casters or legs to the mounting bracket
with ¼" – 20 Philips head screws provided
To comply with NSF requirements,
NOTICE
cabinet must be sealed to floor or
on legs, casters, or rollers.
Perlick is committed to continuous improvement. Therefore, we reserve the right to change specifications without prior notice
PLACING THE CABINET
To assure maximum performance, fresh air must
be allowed to circulate through the machinery
compartment. Do not place anything in front of the
cabinet that would obstruct air flow at these grilles. Do
not place the unit in an unventilated small room.
Cabinet should be leveled front to
NOTICE
back then side to side
ANTI-TIP (WITHOUT LEGS, CASTERS OR
ROLLERS)
To prevent the cabinet from
WARNING
tipping forward and to provide a
stable installation, the cabinet must be secured in
place with an anti-tip device.
Metal anti-tip brackets are supplied. These brackets
should be attached to the floor, at the back of the cabinet'
each bracket located to catch each rear glide when the
cabinet is pushed back into position.
The anti-tip brackets must catch
WARNING
each of the glides to have a stable
& safe installation.
Some installations sites may need to be modified to
provide a secure surface for attaching the bracket. Refer
to the illustration below for anti-tip mounting bracket
locations.
6
Advertisement
Table of Contents
