Perlick SIGNATURE Series Installation Manual

Perlick SIGNATURE Series Installation Manual

Hide thumbs Also See for SIGNATURE Series:

Advertisement

Quick Links

Installation Manual
HP15
HP24
HP48
HH24
HC24
HA24
15" SIGNATURE SERIES
24" SIGNATURE SERIES
48" SIGNATURE SERIES
SIGNATURE SERIES SOTTILE
C-SERIES
ADA-COMPLIANT SERIES
Form No. Z2348-B
Rev. 11.10.2015

Advertisement

Table of Contents
loading

Summary of Contents for Perlick SIGNATURE Series

  • Page 1 Installation Manual HP15 15” SIGNATURE SERIES HP24 24” SIGNATURE SERIES HP48 48” SIGNATURE SERIES HH24 SIGNATURE SERIES SOTTILE HC24 C-SERIES HA24 ADA-COMPLIANT SERIES Form No. Z2348-B Rev. 11.10.2015...
  • Page 2: Table Of Contents

    (2) year period commencing on the date of purchase by the original retail purchaser if the We thank you again for selecting a high quality Perlick purchase of the product is not registered with Perlick product. We hope you enjoy using it.
  • Page 3 PERLICK RESIDENTIAL INSTALLATION MANUAL REMEDY: This Warranty does not apply to: Perlick will provide the parts and labor necessary to repair • Damage to Products occurring during transportation. or replace (at Perlick’s option) any parts proven to be • Products that are used in a manner that is not normal defective in material or workmanship during the Basic residential or light commercial use.
  • Page 4: Safety Information

    Indicates a hazard MAY cause serious injury or death if precautions are not followed. All Perlick units come equipped with a NEMA 5-15P 90° plug with a 5’ cord extending beyond the rear of the cabinet. The electrical outlet must be flush with, or recessed into, CAUTION the wall surface for all HP, HC and HA models.
  • Page 5: Installation Instructions

    PERLICK RESIDENTIAL INSTALLATION MANUAL Serious Electrocution Hazard! NOTE: Anti-tip brackets are only used for stationary cabinets DANGER Electrical grounding is required. and should not be installed on cabinets with accessory casters. This appliance is equipped with a 3-prong (grounding) Caster kits are available for HP, HC and HA model cabinets.
  • Page 6 1). Plug the unit into the 15 amp grounded electrical requirements: outlet located within the installation opening. With power applied to the unit, check that the lighting and cooling HP15 15” Signature Series functions operate properly. Turn off the power to the wall Height Depth Width outlet at the circuit breaker.
  • Page 7: Toe Kick Installation

    PERLICK RESIDENTIAL INSTALLATION MANUAL TOE PLATE INSTALLATION Once the unit is secured in place, install the louvered toe plate. Secure the plate by snapping the latch into the latch catch on the unit (Figure 5). The toe plate must be removed to CAUTION service the unit.
  • Page 8: Shelving/Drawer Adjustments

    PERLICK RESIDENTIAL INSTALLATION MANUAL SHELVING/DRAWER ADJUSTMENTS DOOR OPTIONS Completely empty shelf or drawer Perlick residential units offer a variety of door panel design CAUTION before removing. alternatives; solid stainless steel, solid wood overlay, glass with stainless steel trim and glass with wood overlay trim.
  • Page 9 PERLICK RESIDENTIAL INSTALLATION MANUAL 5). Using the screws removed in step 3, install the top and bottom hinge brackets from the kit (Fig. 9). Hinge brackets and mounting screws SUPPORT Pull door to the side then lower door Remove hinge pin Figure 7.
  • Page 10 6 (Fig. 14). Figure 11. Removing Front Panel 8). Remove the Perlick nameplate from the door front using a plastic putty knife (Fig. 12). Install the new Perlick nameplate included in the kit. Top hinge...
  • Page 11: Handle Installation

    TOP VIEW NOTE: Full size lock installation wood overlay panel templates Figure 15. Installing V-Block are available on the Perlick website. Visit www.perlick.com/ Residential, click on Service & Support, and then choose Wood Overlay Templates from the menu. Lock templates are 13).
  • Page 12: Wood Overlay Installation

    PERLICK RESIDENTIAL INSTALLATION MANUAL WOOD OVERLAY INSTALLATION WINE RACK TRIM (OPTIONAL) (FOR -2, -4 AND -6 MODELS) All wine reserve racks come with sleek stainless steel fronts. Before beginning installation, check all components for Unfinished solid hardwood fronts are optional and can be proper fit and finish.
  • Page 13 Contact Perlick Customer or Technical Service at 800.558.5592. Customer Service and Technical Service are available business days Monday through Friday from 7:00 a.m. to 7:00 p.m. CST. 8300 W. Good Hope Road, Milwaukee, WI 53223 • 800.558.5592 • info@perlick.com • www.perlick.com Form No. Z2348-B Rev. 11.10.2015...

Table of Contents