GRAUPNER MZ-10 HOTT Operating Instructions Manual page 6

5
Unscrew the tension spring control
bolt in the elevator gimbal of mode
1 transmitter
7
Assemble 2pcs of disassembled leaf
spring from the throttle gimbal of
mode 1 transmitter into the elevator
gimbal and adjust the bolt for the
desired control
6
6
Screw the disassembled bolt from
the throttle gimbal of mode 1 trans-
mitter into the elevator gimbal to fix
the controller
8
Assemble the disassembled centering
cam form the elevator gimbal of mode 1
transmitter into the throttle gimbal pin
9
Assemble the centering cam into the
throttle gimbal of mode 1 transmitter and
set the spring in the center control part and
the centering cam with tweezers
Tension spring
Assemble the transmitter's rear case and switch to mode 2 from mode 1 at Stick mode
page in the transmitter programming setup section according to the manual.
NOTICE
Make sure to test all functions are normally operated in mode 2 before flying
10
Screw the disassembled tension
control bolt from the elevator gimbal
of mode 1 transmitter into the throttle
gimbal and adjust the bolt for the
desired control