GRAUPNER MZ-10 HOTT Operating Instructions Manual page 15

• KC Information
Product(s) : Graupner /SJ mz-10 Transmitter
- KCC인증번호: KCC-RRM-sjr-16005000, KCC-CRM-sjr-36204210
- 방송통신위원회고시 제2013-01호 "무선설비규칙"
- 방송통신위원회고시 제2012-102호 "신고하지 아니하고 개설할 수 있는 무선기기"
KN 301 489-1:2009
KN 301 489-17:2009
KN 61000-4-2:2008
KN 61000-4-3:2011
Product(s) : Graupner/SJ GR-12L 6 Channel HoTT Receiver
- KCC인증번호: KCC-CRM-sjr-16003510
- 방송통신위원회고시 제2013-01호
- 방송통신위원회고시 제2012-102호 "신고하지 아니하고 개설할 수 있는 무선기기"
• Caution
- This equipment's aerial must be at least 20 cm from any person when the system is in use.
We therefore do not recommend using the equipment at a closer range than 20cm.
- Ensure that no other transmitter is closer than 20cm from your equipment, in order to avoid
adverse effects on the system's electrical characteristics and radiation pattern.
- The radio control system should not be operated until the Country setting has been set
correctly at the transmitter. This is essential in order to fulfill the requirements of various
directives - FCC, ETSI, CE, KC and etc. Please refer to the instructions for your particular
transmitter and receiver for details of this procedure.
- Check all working systems and carry out at least one full range check on the ground before
every flight, in order to show up any errors in the system and the models programming.
- Never make any changes to the programming of the transmitter or receiver whilst operat-
ing a model.
• Caution
- This equipment's aerial must be at least 20 cm from any person when the system is in
use. We therefore do not recommend using the equipment at a closer range than 20cm.
- Ensure that no other transmitter is closer than 20cm from your equipment, in order to
avoid adverse effects on the system's electrical characteristics and radiation pattern.
- The radio control system should not be operated until the Country setting has been set
correctly at the transmitter. This is essential in order to fulfill the requirements of various
directives - FCC, ETSI, CE, KC and etc. Please refer to the instructions for your particular
transmitter and receiver for details of this procedure.
- Check all working systems and carry out at least one full range check on the ground
before every flight, in order to show up any errors in the system and the models program-
ming.
- Never make any changes to the programming of the transmitter or receiver whilst operat-
ing a model.
• ENVIRONMENTAL PROTECTION NOTES
This product must not be disposed of with other waste. Instead,
it is the user's responsibility to their waste equipment by handing it over
to a designated collection point for the recycling of waste electrical and
electronic equipment. The separate collection and recycling of
your waste equipment at the time of disposal will help to conserve natural resources and
ensure that it is recycled in a manner that protects human health and the environment.
For more information about where you can drop off your waste equipment for recycling,
please contact your local city office, your household waste disposal service or where you
purchased the produce
15