Table of Contents
Advertisement
Setting date and time
If the screen shows the incorrect date/time, then
adjust it.
Set to Tape Recording Mode or Card
Recording Mode.
1
Set [BASIC] >> [CLOCK SET] >> [YES].
2
Move the joystick left or right in order to
select the item to be set. Then move the
joystick up or down to set the desired value.
The year will change as follows:
2000, 2001, ..., 2089, 2000, ...
The 12-hour clock is used.
3
Press the joystick to determine the setting.
The clock function starts at [00] seconds.
About date/time
The date and time function are driven by a
built-in lithium battery.
Make sure to check the time before recording
because the built-in clock is not very accurate.
Recharging the built-in lithium battery
If [
] or [--] is indicated when the Camcorder is
turned on, then the built-in lithium battery has
run down. Connect the AC adaptor to the
Camcorder or place the battery on the
Camcorder, and the built-in lithium battery will
be recharged. Leave the Camcorder as is for
approx. 24 hours, and the battery will drive the
date and time for approx. 6 months. (Even if the
[OFF/ON] switch is set to [OFF], the battery is
still being recharged.)
Before using
Adjusting LCD monitor/viewfinder
Adjusting the brightness and color
level
1
Set [SETUP] >> [LCD SET] or [EVF SET] >>
[YES].
2
Move the joystick up or down in order to
select the item to be adjusted.
[LCD SET]
:
Brightness of the LCD monitor
:
Color level of the LCD monitor
[EVF SET]
:
Brightness of the viewfinder
EVF
3
Move the joystick left or right to move the
bar indication representing the brightness.
4
Press the [MENU] button or the joystick to
complete the settings.
In order to adjust the brightness of the
viewfinder, close the LCD monitor, and the
viewfinder will be activated.
When the LCD monitor is rotated by 180°
towards the lens, the brightness of the LCD
monitor cannot be adjusted.
These settings will not affect the images actually
recorded.
23
LSQT0862
Hide quick links:
Advertisement
Table of Contents
