Fitting The Lens Cap - Panasonic PV-GS250 Operating Instructions Manual

(41)
(41)
Tripod receptacle
This is a hole for attaching the Camcorder to
optional tripod. (Please carefully read the
operating instructions for how to attach the tripod
to the Camcorder.)
When the tripod is used, operate the Camcorder
from the Magic Wire Remote Control with
Narration Mic for convenience. (When not using
the remote control, attach the clip to the grip belt
for convenience. When you move with remote
control attached to a pocket, etc., take care to
avoid tipping over the tripod.)
You cannot open the card slot cover when the
tripod is used. Insert the card first and then
attach the tripod.
(42)
Shoulder strap fixture
Put the strap through the fixture
the stopper so it will not come off. Extend
part by at least 1 inch (2 cm).
Fit the other end of the belt similarly.
14
LSQT0862
Before using
(43)
In order to remove the lens hood, rotate it
counter-clockwise
, and then rotate it clockwise.

Fitting the lens cap

Fit the lens cap to protect the surface of the lens.
1
Remove the grip belt. Run the end of the
lens cap cord through the hole in the grip
belt attachment and run the lens cap
through the lens cap cord.
The lens cap removed can be attached to the
lens cap fixture. (It cannot be hung if the grip
belt is used as a hand strap.)
(42)
To fit or remove the lens cap, hold both sides of
and through the lens cap with the tips of your finger and
thumb.
(43)
Lens hood
. In order to fit it, put into slot