Table of Contents
Advertisement
5
Setup
When the unit is turned on for the first time, a message asking you to set the date and time will appear.
Select [YES] and perform steps 2 to 3 below to set the date and time.
¬ Rotate the mode dial to select
1
Select the menu. (l 29)
[SETUP] # [CLOCK SET] # [YES]
2
Select the date or time to be set,
then set the desired value with
the cursor button.
≥ The year will change as follows:
2000, 2001, ..., 2039, 2000, ...
≥ The 12-hour system is used to display the time.
≥ [
] appears on the right top of the screen
when [SET WORLD TIME] (l 34) is set to
[HOME], while [
[DESTINATION].
3
Press the cursor button to enter
the selection.
≥ The clock function starts at [00] seconds when
the cursor button is pressed.
Changing the date and time display mode
Select the menu. (l 29)
[SETUP] # [DATE/TIME] # desired display
style
≥ You can also show or change the date and
time display by repeatedly pressing the DATE/
TIME button on the remote control.
Setting date and time
.
] appears when it is set to
[DATE]
NOV 15 2008
[OFF]
Changing the date format
Select the menu. (l 29)
[SETUP] # [DATE FORMAT] # desired
display style
Display style
[Y/M/D]
[M/D/Y]
[D/M/Y]
≥ To set daylight saving time, select the daylight
saving time in [HOME] for [SET WORLD TIME]
after setting the clock.
≥ The date and time function is driven by a built-
in lithium battery.
≥ If the time display becomes [- -], the built-in
lithium battery needs to be charged. Use the
following steps to charge the battery.
To recharge the built-in lithium battery
≥ Connect the AC adaptor or attach the battery
to this unit, and the built-in lithium battery will
be recharged. Leave the unit as it is for approx.
24 hours and the battery will maintain the date
and time for approx. 6 months. (The battery is
still being recharged even if the mode dial is
set to OFF.)
[D/T]
NOV 15 2008 12:34PM
Screen display
2008. 11. 15
NOV 15 2008
15. 11. 2008
33
VQT1T64
Advertisement
Table of Contents
