Panasonic PV-GS250 Operating Instructions Manual page 50

5
Press the [ ] button on the remote control
to start audio dubbing.
/REW PLAY FF/
STILL ADV PAUSE STILL ADV
STOP
When the Magic Wire Remote Control with
Narration Mic is used, start recording with the
[TALK] button pressed.
Talk into the microphone. Or start play on the
playing device.
6
Press the [ ] button on the remote control
to stop audio dubbing.
/REW
STILL ADV
If a tape has a non-recorded portion when the
tape is dubbed, images and sounds may be
disturbed when this portion of the tape is played
back.
Before recording with audio dubbing
Set to Tape Recording Mode.
When you want to preserve the original sound
taken during recording, set [SETUP] >>
[AUDIO REC] >> [12bit] to take pictures. (When
set [16bit], the sounds taken during recording
are erased after recording with audio dubbing.)
Set [BASIC] >> [REC SPEED] >> [SP] to take
pictures.
To play back the sound recorded with
audio dubbing
You can switch between the sound recorded with
audio dubbing and the original sound.
Set [SETUP] >> [12bit AUDIO] >> [ST2] or [MIX].
[ST1]: It only plays back the original sound.
[ST2]: It only plays back the sound added by
audio dubbing.
[MIX]: It simultaneously plays back the original
sound and the sound added with audio
dubbing.
To dub audio while listening to a
pre-recorded sound
When pausing the audio dubbing, set the
[12bit AUDIO] on the [SETUP] Sub-Menu to
[ST2] and you can check the pre-recorded
sound. When the line input is used, you can dub
audio while listening to the pre-recorded sound
from the speaker.
50
LSQT0862
A.DUB
W
VOL
PLAY FF/
W
VOL
PAUSE STILL ADV
STOP
Edit mode