Charging Time And Recordable Time - Panasonic PV-GS250 Operating Instructions Manual

Connecting to the AC outlet
1
Connect the AC cable to the AC adaptor and
the AC jack.
2
Connect the DC cable to the AC adaptor.
3
Connect the DC cable to this product.
Lift up the viewfinder beforehand.
The output plug of the AC cable is not
completely connected to the AC adaptor jack.
As shown in , there is a gap.
Do not use the power cord for other
equipment since the power cord is exclusively
designed for this Camcorder. Do not use the
power cord from other equipment for this
Camcorder.
Fitting the battery
Push the battery against the battery holder and
slide it until it clicks.
Removing the battery
While pushing the [PUSH BATT] button, slide the
battery (or the DC input lead) to remove it.
Hold the battery with your hand so it does not
fall.
Before using

Charging time and recordable time

The times shown in the table below show the
times at a temperature of 68 F (25 C) and a
humidity of 60%. This is just a guide. If the
temperature is higher or lower than the specified
value, the charging time will become longer.
Supplied
1
CGA-DU12
1150 mAh)
CGA-DU21
2040 mAh)
CGR-DU06
640 mAh)
"1h. 10 min." indicates 1 hour 10 minutes.
The battery CGA-DU12 is supplied.
The times shown in the table are rough
estimates. The times indicate the recordable
time when the viewfinder is used. The times in
parentheses indicate the recordable time when
the LCD monitor is used.
We recommend the Battery Pack CGA-DU12
and CGA-DU21 for long recording time (2 hour
or more for continuous recording, 1 hour or
more for intermittent recording).
The recordable time will become shorter in the
following cases:
When you use both the viewfinder and the
LCD monitor simultaneously while rotating
the LCD monitor frontward to record yourself,
0 Lux MagicPix function, etc.
When you use this Camcorder with the LCD
monitor lit up by pressing the [POWER LCD]
button.
When you use accessories fitted on the
Camcorder's smart accessory shoe such as
the stereo zoom microphone and video DC
light, etc..
PUSH
BATT
The batteries heat up after use or charging. The
Camcorder being used will also heat up. This is
normal.
Along with the reduction of the battery capacity,
the display will change:
discharges, then
battery/
(7.2 V/
(7.2 V/
(7.2 V/
Charging time
Maximum continuously recordable time
(
2 h. 25 min.
2 h. 5 min.
(1 h. 55 min.)
3 h. 55 min.
3 h. 30 min.
(3 h. 15 min.)
1 h. 40 min.
1 h. 5 min.
(1 h.)
. If the battery
) will flash.
17
LSQT0862